20 Tips To Prevent False Alarms

CONTROL EQUIPMENT
1. Take the mains supply from the consumer board
2. Charge batteries overnight before using them
3. On larger systems, power PIRs from a separate PSU
4. Make sure PSUs come off the same phase/Earth mains supply
5. Always eliminate induced AC by fitting a ACT1313 12 volt spike suppressor

ALARM CABLES
6. Don't run alarm cables next to mains or any other service cables
7. Connect unused spare wires down to Earth
8. Always use screened cable for keypads, LIMs and iD circuits
9. Never run data and sounder circuits in the same cable
10. Use insulated staples in staple guns
11. Always solder twisted joints on EOL and iD circuits

PIR DETECTORS
12. Choose PIRs fitted with genuine white light filters
13. Don't fit PIRs within 50 percent of their range facing glass
14. Avoid placing PIRs close to radiators, fireplaces and boilers etc
15. Make sure all windows and doors are closed
16. Seal PIR entry holes, especially where cables come through walls
17. Use dual technology where insects and rodents are a problem
18. Make sure the DC supply is above 13 volts and stable
19. Fit a PIR stabiliser to prevent false alarms caused by RFI

COMMISSIONING
20. Complete our 'control panel checklist' as part of your procedure